3Com 3031 Command Reference Manual page 113

debugging ntp-service 113
View
System view
Parameter
interface-type: Interface type, which determines an interface along with the
interface-number.
interface-number: Interface number, which determines an interface along with the
interface-type.
Description
Using the ntp-service source-interface command, you can specify the interface for
the local end to transmit NTP messages. Using the undo ntp-service
source-interface command, you can delete the interface for the local end to
transmit NTP messages.
The source IP address is determined by the output interface.
The source IP address is the specified one when specifying the local to transmit all
the NTP messages. The IP address is obtained from the specified interface. If the
user does not want the IP addresses on other interfaces to become the destination
address responding to the messages, this command can be used to specify one
interface to send all the NTP packets.
Example
Specify the source IP address of all the NTP output packets to use the IP address
on the interface Ethernet 1/0/0.
[3Com] ntp-service source-interface ethernet 1/0/0
ntp-service unicast-peer Syntax
ntp-service unicast-peer X.X.X.X [ version number | authentication-key keyid |
source-interface {interface-type interface-number } | priority ] *
undo ntp-service unicast-peer X.X.X.X
View
System view
Parameter
X.X.X.X: IP address of the remote server.
version: Defines the NTP version number.
number: NTP version number in the range of 1 to 3.
authentication-keyid: Defines ID authentication key.