3Com 3031 Command Reference Manual page 247

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

PPP and MP Configuration Commands

Interface view

Using the ppp mp command, you can enable the interface encapsulated with PPP

to operate in the MP mode. Using the undo ppp mp command, you can enable

the interface to operate in the Single PPP mode.

By default, the interface encapsulated with PPP operates in the Single PPP mode.

To increase the bandwidth, multiple PPP links can be bound to form a logical MP

interface. For this purpose, it is necessary to specify a virtual-template in system

view. MP can be configured and used only at the physical interfaces which can

encapsulate PPP. To enable MP, you must configure the ppp mp command and the

PAP or CHAP authentication at the physical interface.

For the related commands, see link-protocol ppp, ppp mp user, and interface

virtual-template.

Configure the PPP encapsulated interface Serial0/0/0 to work in MP mode.

[3Com-Serial1/0/0] ppp mp

ppp mp lfi [ delay-per-frag max-delay ]

undo ppp mp lfi [ delay-per-frag ]

Virtual template interface view

max-delay: Maximum delay in millisecond, its value ranges from 1 to 1000.

Using the ppp mp lfi command, you can configure the link fragmentation and

interleaving features. Using the undo ppp mp lfi command, you can restore the

default configuration.