3Com 3031 Command Reference Manual page 464

464 C 5: N
HAPTER ETWORK
nat server
P
ROTOCOL
[3Com-acl-basic-1] rule permit source 10.110.10.0 0.0.0.255
[3Com-acl-basic-1] rule deny
Configure the address pool.
[3Com] nat address-group 1 202.110.10.10 202.110.10.12
Allow address translation and use the addresses of address pool 1 for address
translation. During translation, the information of TCP/UDP port is used.
[3Com-Serial0/0/0] nat outbound 1 address-group 1
Delete the corresponding configuration.
[3Com-Serial0/0/0] undo outbound 1 address-group 1
Configuration of simple address translation (not using the TCP/UDP port
information to perform the address translation)
[3Com-Serial1/0/0] nat outbound 1 address-group 1 no-pat
Delete the corresponding configuration.
[3Com-Serial0/0/0] undo nat outbound 1 address-group 1 no-pat
The configuration that can be used when performing address translation by using
the IP address of interface Serial0/0/0 directly.
[3Com-Serial0/0/0] nat outbound 1
Delete the corresponding configuration.
[3Com-Serial0/0/0] undo nat outbound 1
Syntax
nat server [ vpn-instance vpn-instance-name ] protocol pro-type global global-addr
global-port1 global-port2 inside host-addr1 host-addr2 host-port
nat server [ vpn-instance vpn-instance-name ] protocol pro-type global global-addr
[ global-port ] inside host-addr [ host-port ]
undo nat server [ vpn-instance vpn-instance-name ] protocol pro-type global
global-addr global-port1 global-port2 inside host-addr1 host-addr2 host-port
undo nat server [ vpn-instance vpn-instance-name ] protocol pro-type global
global-addr [ global-port ] inside host-addr [ host-port ]
View
Interface view
Parameter
vpn-instance-name: The virtual route forwarding instance of the VPN the
internal server belongs to. If the parameter is not configured, it represents that
the internal server belongs to an ordinary private network, other than one
MPLS VPN.