3Com 3031 Command Reference Manual page 504

504 C 5: N
HAPTER ETWORK
ipx update-change-only
ping ipx
P
ROTOCOL
Description
Using the ipx tick command, you can configure the delay of interface sending IPX
packets. Using the undo ipx tick command, you can restore the default value of
interface delay.
As the IPX RIP delay field, the delay value configured by the ipx tick command is a
basis for the optimal routing selection.
Example
Configure the delay is 5 ticks on the interface Ethernet1/0/0.
[3Com-Ethernet1/0/0] ipx tick 5
Syntax
ipx update-change-only
undo ipx update-change-only
View
Interface view
Parameter
None
Description
Using the ipx update-change-only command, you can enable trigger update on
the current interface. Using the undo ipx update-change-only command, you can
disable trigger update on the current interface.
By default, trigger update is disabled on the interface.
IPX RIP and SAP periodically advertise updating broadcast packets. Users can
configure trigger update to avoid broadcast flood.
Example
Enable trigger update on the interface Ethernet1/1/0.
[3Com-Ethernet 1/1/0] ipx update-change-only
Disable trigger update on the interface Ethernet1/1/0.
[3Com-Ethernet 1/1/0] undo ipx update-change-only
Syntax
ping ipx network.node [ -c count ] [ -t timeout ] [ -s size ]
View
Any view
Parameter
network.node: Ping destination address. The parameter network can be an
eight-bit hexadecimal number ranging from 0x1 to 0xFFFFFFFD. The 0s in front
can be omitted when inputting. The parameter node is a 48-bit value
represented by a triplet of four-digit hexadecimal numbers separated by "-".