3Com 3031 Command Reference Manual page 101

3.1.23
Syntax
user privilege level level
undo user privilege level
View
User interface view
Parameter
level: Command level in the range of 0 to 3.
Description
Using the user privilege command, you can configure the command accessing
level commensurate with the users accessing the system from the current user
interface. Using the undo user privilege command, you can disable the current
setting.
By default, the default command accessing levels of CON user interface and other
user interfaces have been set to 3 and 0.
If the command accessing level assigned to a user interface conflicts with the
precedence level assigned to the used username in the granted rights, the rights
commensurate with the username will be preferred. For example, the precedence
of the user 007 allows 007 to access level-3 commands and the privilege level
assigned to the user interface VTY 0 only allows the login users to access level-2
commands. If 007 accesses the system from VTY0 in this case, it will be able to
access the commands of level-3 and lower levels.
Example
Assign the users accessing the system from the user interface with the privilege
allowing them to access level-2 commands.
[3Com-ui-vty0] user privilege level 2
After the user accesses the router from vty 0 via Telnet, the terminal will display:
<3Com>
user-interface
Syntax
user-interface [ type-keyword ] user-interface-number [
ending-user-interface-number ]
View
System view
user privilege
User Interface Configuration Commands 101