3Com 3031 Command Reference Manual page 39

Information Processing Commands 39
Only when the information center has been enabled can this command become
effective.
By setting the IP address of loghost, you can specify the information outbound
direction. You can set up to 4 loghosts.
For related command, see info-center enable, and display info-center.
Example
Enable the router to send information to the UNIX workstation at 202.38.160.1.
[3Com] info-center loghost 202.38.160.1
info-center loghost
Syntax
source
info-center loghost source interface-type interface-number [ subinterface-type ]
undo info-center loghost source
View
System view
Parameter
interface-type: Interface types.
interface-number: Number of the interface.
subinterface-name: Subinterface types.
Description
The info-center loghost source command is used to specify the source address for
sending packets to the logging host while the undo inforcenter loghost source
command is used to cancel the current configuration.undo info-center loghost
source is for the canceling of the current configuration.
When a logging message is sent out from a router, the default source address is
the IP address of the interface which has sent the logging message. If the user
wants to change the source address, he can use this command to achieve it. You
can judge which router has sent out the message by setting different source
addresses for different routers, accordingly you can also search among the
received messages.
Example
Set the IP address of Loopback0 as the source address of the logging message
packets.
[3Com] interface loopback 0
[3Com-LoopBack0] ip address 1.1.1.1 255.255.255.0
[3Com-LoopBack0] quit
[3Com] info-center loghost source loopback 0