3Com 3031 Command Reference Manual page 331

ATM Configuration Commands 331
ATM VC-CLASS: main
Service ubr 8000
encapsulation aal5snap
The explanation on the above messages is:
ATM-Class name is "main", and the following contents are set in the ATM-Class:
the service type is unspecified bit rate and the output peak rate of ATM cells is
8000 and the AAL encapsulation type is SNAP.
display atm interface Syntax
display atm interface [ interface-name | interface-type interface-num ]
View
Any view
Parameter
interface-name: ATM interface name. For detailed naming rules, please refer to
"Interface Configuration" part of this manual. If it is not specified, all the
information about ATM interface will be displayed by default.
interface-type: Interface type, which can determine an ATM interface together
with interface-num.
interface-num: Interface number, which can determine an ATM interface together
with interface-type.
Description
Using the display atm interface command, you can locate the problems efficiently
and get detailed information related to ATM configuration.
The interface-name parameter is actually composed of interface-type and
interface-num. The difference of using them only lies in the space. In the
command line, there are spaces in interface-type and interface-num, but there is
no space in interface-name. When the interface is the main interface, the
information of all interfaces (including sub-interface) at the interface will be
displayed.
For the related command, see display atm.
Example
Display the information about ATM interface atm4/0/0.
<3Com> display atm interface atm 4/0/0
The following information is displayed:
ATM interface Atm4/0/0, State UP
Port Information:
Maximum VCs: 1024,
PVCs: 4, MAPs: 4