3Com 3031 Command Reference Manual page 585

View
OSPF view
Parameter
None
Description
Using the opaque-capability enable command, you can enable the Opaque
capability of OSPF. Using the undo opaque-capability command, you can disable
the Opaque capability of OSPF.
CAUTION: By default, Opaque capability of OSPF is enabled.
If the application based on Opaque LSA is enabled, for example, the area TE
capability is enabled, the Opaque capability cannot be disabled.
Example
Enable Opaque capability.
[3Com-ospf-100] opaque-capability enable
ospf Syntax
ospf [ process-id ]
undo ospf [ process-id ]
View
System view
Parameter
process-id: Number of OSPF. If no process number is specified, the default
number 1 is used.
Description
Using the ospf command, you can enable the OSPF protocol. Using the undo ospf
command, you can disable the OSPF protocol.
After enabling OSPF protocol, the user can make the corresponding configuration
in OSPF view.
By default, the system does not run the OSPF protocol.
VRP supports OSPF multi-process. Multiple OSPF processes can be enabled by
specifying different process numbers on a router.
It is suggested that user should specify router-id with parameter router-id when
enabling OSPF. Different router-ids should be specified for different processes if
multiple processes are enabled on the router.
For the related command, see network.
Example
Enable the running of the OSPF protocol.
[3Com] router id 10.110.1.8
[3Com] ospf
OSPF Configuration Commands 585