3Com 3031 Command Reference Manual page 276

276 C 4: L L P
HAPTER INK AYER ROTOCOL
[3Com-Bri0/0/0] isdn ignore llc
isdn ignore Syntax
sending-complete
isdn ignore sending-complete [ incoming | outgoing ]
undo isdn ignore sending-complete [ incoming | outgoing ]
View
ISDN interface view
Parameter
incoming: Ignores the Sending Complete Information Element in SETUP messages
with respect to incoming calls.
outgoing: Sends SETUP messages without the Sending Complete Information
Element with respect to outgoing calls.
Description
Using the isdn ignore sending-complete command, you can configure the ISDN
protocol to ignore the processing on the Sending Complete Information Element.
Using the undo isdn ignore sending-complete command, you can restore the
default setting.
By default, in the event that the router is communicating with an exchange, the
ISDN protocol checks whether the received SETUP messages carry the Sending
Complete Information Element with respect to incoming calls and carries the
Sending Complete Information Element in SETUP messages with respect to
outgoing calls.
In the event that the router is communicating with an ISDN exchange, its settings
must be the same as those on the exchange.
You are not allowed to configure this command on an ISDN interface if there is still
a call on it. This command can take effect only if it is configured when there is no
call on the interface. Alternatively, you can manually disable the interface by
executing the shutdown command, configure the command, and then enable the
interface by executing the undo shutdown command. The operations, however,
will lead to the disconnection of the call existing on the interface.
You can configure this command on an interface only when the ISDN protocol
running on the interface is DSS1 or ETSI.
Example
Ignore the Sending Complete Information Element in the received SETUP
messages.
[3Com-Bri0/0/0] isdn ignore sending-complete incoming
Disable carrying the Sending Complete Information Element in the transmitted
SETUP messages.