3Com 3031 Command Reference Manual page 295

Frame Relay Configuration Commands 295
display fr interface Syntax
display fr interface interface-type interface-num
View
Any view
Parameter
interface-type interface-num: Used to specify the interface to be viewed. The
specified interface can be a main interface or a sub-interface. The whole
information will be displayed for the command without specifying an interface.
Description
Using the display fr interface command, you can view the FR status, which is
helpful for you to perform fault diagnosis.
For the related command, see display interface.
Example
Display the FR protocol status.
<3Com> display fr interface
Serial1/0/0, DTE, physical up, protocol up
Serial1/0/0.1, multi-point, protocol up
Serial1/0/0.2, point-to-point, protocol down
Serial2/0/0, DCE, physical down, protocol down
This command displays the protocol status of each interface encapsulated with FR.
The above information indicates that: Frame Relay interface type of Serial1/0/0 is
DTE. Physical layer protocol and link layer protocol of Serial1/0/0 are activated.
display fr lmi-info Syntax
display fr lmi-info [ interface interface-type interface-num ]
View
Any view
Parameter
interface-type interface-num: Used to specify the interface to be viewed. The
whole information will be displayed for the command without specifying an
interface.
Description
Using the display fr lmi-info command, you can view the statistics of LMI protocol
frame.