3Com 3031 Command Reference Manual page 189

display controller e3
Description
Using the controller e3 command, you can enter the CE3 interface view.
For related command, see display controller e3.
Example
Enter the view of the interface E3 1/0/0.
[3com]controller e3 1/0/0
[3com-E3 1/0/0]
Syntax
display controller e3 interface-number
View
Any view
Parameter
interface-number: CE3 interface number.
Description
Using the display controller e3 command, you can view the state information of a
CE3 interface.
In addition to the state information of the CE3 interface, the command can display
the information of each E1 line on the CE3 interface if the interface is working in
CE3 mode.
Example
Display the information related to the interface E3 1/0/0.
[3com]display controller e3 1/0/0
E3 1/0/0 is up
Description : 3Com Routers, E3 1/0 Interface
Applique type is CE3 - 75 OHM unbalanced
code HDB3, clock slave, national-bit 1,loopback not set
Alarm: none
ERROR: 0 BPV, 0 EXZ, 0 FrmErr, 0 FEBE
E3-0 CE1 1 is up
Frame-format NO-CRC4, clock master, loopback not set
E3-0 CE1 2 is up
Frame-format NO-CRC4, clock slave, loopback local
E3-0 CE1 3 is up
Frame-format NO-CRC4, clock slave, loopback remote
E3-0 CE1 4 is up
Frame-format CRC4, clock slave, loopback not set
E3-0 CE1 5 is up
Frame-format NO-CRC4, clock slave, loopback not set
E3-0 CE1 6 is up
Frame-format NO-CRC4, clock slave, loopback not set
Fundamental CE3 Interface Configuration Commands
Frame-format G751, line
189