3Com 3031 Command Reference Manual page 833

mpls te loop-detection
mpls te
max-link-bandwidth
mpls te
max-reservable-bandwi
dth
Syntax
mpls te loop-detection
undo mpls te loop-detection
View
Tunnel view
Parameter
None
Description
Using the mpls te loop-detection command, you can indicate to run loop test in
creating tunnels. Using the undo mpls te loop-detection command, you can
remove loop test.
For signaling protocol, loop testing is optional.
By default, loop detection is disabled.
Example
Indicate to run loop test in creating tunnels.
[3Com-tunnel1] mpls te loop-detection
Syntax
mpls te max-link-bandwidth bandwidth
undo mpls te max-link-bandwidth
View
Interface view
Parameter
bandwidth: Maximum link bandwidth at the interface, in the range of
0~32000000bps. By default, it is the actual bandwidth of the physical interface.
Description
Using the mpls te max-link-bandwidth command, you can configure maximum
link bandwidth at the interface. Using the undo mpls te max-link-bandwidth
command, you can restore the default value.
Example
Set the maximum bandwidth at the interface as 64kbps.
[3Com-Ethernet1/0/0] mpls te max-link-bandwidth 64
Syntax
mpls te max-reservable-bandwidth bandwidth
undo mpls te max-reservable-bandwidth
MPLS TE Configuration Commands 833