3Com 3031 Command Reference Manual page 829

MPLS TE Configuration Commands 829
For related command, see opaque-capability enable.
Example
Enable TE function in OSPF area.
[3Com-ospf-100] area 1
[3Com-ospf-100-area-0.0.0.1] mpls-te enable
mpls te Syntax
mpls te
undo mpls te
View
MPLS view, interface view
Parameter
None
Description
Using the mpls te command, you can enable MPLS TE feature. Using the undo
mpls te command, you can disable MPLS TE feature.
You need to enable this feature both globally and on the interface, and then the
interface will flood this resource information to the right IGP link state database
and accept TE tunnel signaling request.
By default, MPLS TE feature is disabled.
Example
Globally enable MPLS TE feature.
[3Com-mpls] mpls te
Enable MPLS TE feature at the interface Ethernet1/0/0.
[3Com] interface Ethernet1/0/0
[3Com-Ethernet1/0/0] mpls te
mpls te bandwidth Syntax
mpls te bandwidth bandwidth
undo mpls te bandwidth
View
Tunnel view
Parameter
bandwidth: Bandwidth for the tunnel, in kbps. By default, it is 0.