3Com 3031 Command Reference Manual page 498

498 C 5: N
HAPTER ETWORK
ipx route
max-reserve-path
ipx sap disable
P
ROTOCOL
[3Com] ipx route load-balance-path 30
Syntax
ipx route max-reserve-path paths
undo ipx route max-reserve-path
View
System view
Parameter
paths: The maximum dynamic route number to the same destination address,
ranging from 1 to 255. By default, the value is 4.
Description
Using the ipx route max-reserve-path command, you can configure the maximum
dynamic route number to the same destination address. Using the undo ipx route
max-reserve-path command, you can restore the default configuration.
When the dynamic route number to the same destination address exceeds the
maximum value configured, the newly found dynamic routes will not be added
into the routing table, discarded directly. If the newly configured value is less than
the original one, the excessive routes in the current routing table will not be
deleted until they get aging themselves or are deleted manually.
Example
Configure the maximum dynamic route number to the same destination address
to 200.
[3Com] ipx route max-reserve-path 200
Syntax
ipx sap disable
undo ipx sap disable
View
Interface view
Parameter
None
Description
Using the ipx sap disable command, you can disable SAP on the current interface.
Using the undo ipx sap disable command, you can enable SAP on the current
interface.
By default, the interface SAP is enabled as soon as IPX is enabled.
Example
Disable SAP on the interface Ethernet0/0/0.
[3Com-Ethernet0/0/0] ipx sap disable