3Com 3031 Command Reference Manual page 632

632 C 6: R P
HAPTER OUTING
debugging bgp
ROTOCOL
policy-name: Route policy name.
Description
Using the dampening command, you can make BGP route attenuation valid or
modify various BGP route attenuation parameters. Using the undo dampening
command, you can make the characteristics invalid.
By default, no route attenuation is configured.
If the parameters are not set, the BGP route attenuation is valid and each
parameter is taken as the default value. half-life-reachable, half-life-unreachable
,reuse, suppress and ceiling are mutually dependent. Once any parameter is
configured, all other parameters should also be specified.
For the related command, see reset dampening, reset bgp flap-info, display bgp
routing-table dampened, and display bgp routing-table flap-info.
Example
Modify various BGP route attenuation parameters.
[3Com-bgp] dampening 15 15 1000 2000 10000
Syntax
debugging bgp { all | event | keepalive | open | packet | route-refresh | update } [
receive | send ] [ verbose ]
View
User view
Parameter
all: Enables all BGP information debugging.
event: Enables BGP event information debugging.
keepalive: Enables BGP Keepalive packet information debugging.
open: Enables BGP Open packet information debugging.
packet: Enables BGP packet information debugging.
route-refresh: Enables BGP route-refresh packet information debugging.
update: Enables BGP Update packet information debugging.
Description
Using the debugging bgp all command, you can enable all the information
debugging of BGP packets and events.
Using the debugging bgp event command, you can enable the information
debugging of BGP events.
Using the debugging bgp keepalive command, you can enable the information
debugging of BGP Keepalive packets.
Using the debugging bgp packet command, you can enable the information
debugging of BGP packets.
System performance is influenced when information debugging is enabled.
Therefore, this command should be used cautiously. You should disable it after
debugging.