3Com 3031 Command Reference Manual page 302

302 C 4: L L
HAPTER INK AYER
fr compression frf9
P
ROTOCOL
Cause code
Ack timer
Hello timer
Max retry count
Current count
Peer LID
Syntax
fr compression frf9
undo fr compression
View
Frame relay interface view
Parameter
None
Description
Using the fr compression frf9 command, you can enable frame relay compression
function. Using the undo fr compression command, you can disable frame relay
compression function.
By default, frame relay compression function is disabled.
This command is only valid for point-to-point interfaces. In other words, it is used
for frame relay sub-interfaces of point-to-point type.
Only when the frame relay packets type of the interface is IETF, can frame relay
compression take effect. When this command is configured, the system will
automatically change the packet type of the interface into IETF if the frame relay
packets type of an interface is not IETF.
The reason for bundle link to be in the current state, possibly being the
following values:
inconsistent bundle: The peer has associated the bundle with another bundle, thus
making inconsistent BID.
none: The link is in normal state.
bundle link idle: The peer bundle link is idle, which generally occurs when the peer
bundle interface is disabled.
ack timer expiry: The current link state is caused by the timeout of the local T-ack
timer.
loopback detected: Loopback is enabled on the physical line of local bundle link.
other: Other reasons, such as LID error.
unexpected Add_link: The "add_link" message is received when the
bundle link is in up state. This case may occur when the line protocol is
ready for being enabled and will disappear once the connection is
created.
The time of resending hello message before bundle link receives
acknowledgment message or of waiting for hello acknowledgment
message before resending an "add_link" message used for initial
synchronization.
Interval for bundle link to send hello message
Maximum retry times for bundle link to resend hello message or
resend "Add_link" that is used for initial synchronization before the
bundle link waits for hello acknowledgement message.
Current retry times
Bundle link identifier of the peer link