3Com 3031 Command Reference Manual page 739

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

MSDP Configuration Commands

peer-address: IP address of MSDP peer.

Using the shutdown command, you can disable the MSDP peer specified. Using

the undo shutdown command, you can remove the configuration.

By default, no MSDP peer is disabled.

For the related command, see peer.

Disable the MSDP peer 125.10.7.6.

<3Com> system-view

<3Com-msdp] shutdown 125.10.7.6

static-rpf-peer

static-rpf-peer peer-address [ rp-policy list ]

undo static-rpf-peer peer-address

peer-address: Address of the static RPF peer to receive SA messages.

rp-policy list: Filter policy based on RP address, which filters the RP in SA messages.

If the parameter is not specified, all SA messages from static RPF peer will be

accepted. If the parameter rp-policy list is specified and filter policy is configured,

the router will only accept SA messages from the RP which passes filtering. If no

filter policy is configured, the router will still accept all SA messages from the static

Using the static-rpf-peer command, you can configure static RPF peer.. Using the

undo static-rpf-peer command, you can remove the static RPF peer.

By default, no static RPF peer is configured.

You must configure the peer command before using the static-rpf-peer command.

If you do not want to perform RPF check to SA messages from a same MSDP peer.

If only an MSDP peer is configured on a router, this MSDP peer will be regarded as

static RPF peer.

For the related commands, see peer and ip prefix-list.