Chapter 1 Static Route Configuration Commands; Display Ip Routing-Table - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00

Chapter 1 Static Route Configuration Commands

1.1 Static Route Configuration Commands

1.1.1 display ip routing-table

Syntax
display ip routing-table [ ip-address ]
View
All views
Parameter
ip-address: Display the routing items of a special IP address. By default, no IP
address is specified.
Description
Using the display ip routing-table command, you can view the summary of a routing
table.
This command can also be used when the routing table is too large and the user only
wishes to display the detail of several specified routes. According to the information
output through this command, the user can make sure if the specified routes exist or if
its status is correct.
If the specified routes are those in a natural hop like 10.0.0.0, then the execution of
this command will display the detail of all the routes. Otherwise only routing
information corresponding to the specified addresses is displayed.
The output of this command displays the routing table in tabulation. Each row
represents a route, and includes:
Destination address/mask length
Protocol
Preference
Metric
Next hop
Output interface
6