3Com 3031 Command Reference Manual page 604

604 C 6: R
HAPTER OUTING
display isis mesh-group
display isis peer
P
ROTOCOL
IS-IS Level-1 Link State Database
LSPID LSP Seq Num
0050.0500.5004.00-00 0x0000000e
0050.0500.5005.00-00 0x00000010
IS-IS Level-2 Link State Database
LSPID LSP Seq Num
0050.0500.5004.00-00* 0x0000001d
0050.0500.5005.00-00
Syntax
display isis mesh-group
View
Any view
Parameter
None
Description
Using the display isis mesh-group command, you can view the IS-IS mesh group.
This command is used for displaying the configurations of the mesh-group of the
current router interface.
Example
Add Interface serial1/0/0 and Interface serial2/0/0 running IS-IS into mesh group
100.
[3Com-Serial1/0/0] isis mesh-group 100
[3Com-Serial1/0/0] interface Interface serial2/0/0
[3Com-Serial2/0/0] isis mesh-group 100
Display the information of IS-IS mesh-group.
[3Com-serial2/0/0] display isis mesh-group
Serial1/0/0
Serial2/0/0
Syntax
display isis peer [ verbose ]
View
Any view
Parameter
verbose: When this parameter is configured, the area address carried in the
Hello message from the peer will be displayed. Otherwise, only the summary
information will be displayed.
Description
Using the display isis peer command, you can view IS-IS peer information.
The display isis peer verbose command yields not only all the outputs of the display
isis peer command, but also the area address, Up time and IP address of the
directly connected interface of the peer.
LSP Checksum LSP-Holdtime ATT/P/OL
0x3670
0xf94 333
LSP Checksum LSP-Holdtime
0x3e8 1089
0x00000023 0x676e
100
100
1084 0/0/0
0/0/0
ATT/P/OL
0/0/0
343 0/0/0