3Com 3031 Command Reference Manual page 380

380 C 4: L L
HAPTER INK AYER
x25 response
called-address
x25 response
calling-address
P
ROTOCOL
Example
Specify that each VC on the X.25 interface Serial0/0/0 acknowledges each
correctly received data packet.
[3Com-Serial0/0/0] x25 receive-threshold 1
Syntax
x25 response called-address
undo x25 response called-address
View
Interface view
Parameter
None
Description
Using the x25 response called-address command, you can enable X.25 to carry the
address information of the called DTE in sending call reception packet. Using the
undo x25 response called-address command, you can disable the above function.
By default, this function is disabled.
According to X.25, the call receiving packet of a call may or may not carry an
address code group, depending on the specific network requirements. This
command enables users to easily specify whether the call receiving packet of a call
sent by X.25 of the 3Com series routers carries the called DTE address.
For the related commands, see x25 response calling-address, x25 ignore
called-address, and x25 ignore calling-address.
Example
Specify that the call receiving packet of a call sent from the X.25 interface
Serial0/0/0 carries the called DTE address.
[3Com-Serial0/0/0] x25 response called-address
Syntax
x25 response calling-address
undo x25 response calling-address
View
Interface view