3Com 3031 Command Reference Manual page 508

508 C 5: N
HAPTER ETWORK
code nrzi
debugging dlsw
P
ROTOCOL
[3Com] dlsw bridge-group 20
[3Com] interface Ethernet1/0/0
[3Com-Ethernet1/0/0] bridge-set 20
Syntax
code nrzi
undo code
View
Synchronous serial interface system view
Parameter
None
Description
Using the code nrzi command, you can configure the NRZI encoding of the
synchronous serial port. Using the undo code nrzi command, you can remove the
NRZI encoding of the synchronous serial port.
By default, the NRZ encoding is configured on the synchronous serial port.
There are two coding schemes, NRZI and NRZ, available on the synchronous serial
port. The NRZ coding scheme is generally used in our router. The serial port coding
scheme of some SNA devices is the NRZI coding scheme. Therefore the coding
scheme of the router needs to be changed according to the encoding of the
connected device.
Example
Configure the NRZI encoding on the Serial1/0/0.
[3Com-Serial1/0/0] code nrzi
Syntax
debugging dlsw { circuit [ correlator ] | tcp [ ip-address ] }
undo debugging dlsw { circuit [ correlator ] | tcp [ ip-address ] }
View
User view
Parameter
circuit: Enables the DLSw circuit debugging.
correlator: Distinguishes different IDs of the circuits.
tcp: Enables the debugging of the DLSw peers.
ip-address: IP address.
Description
Using the debugging dlsw command, you can enable the DLSw debugging. Using
the undo debugging dlsw command, you can disable the DLSw debugging.