3Com 3031 Command Reference Manual page 611

isis authentication-mode
[3Com-isis] import-route isis level2 into level1 acl 100
isis Syntax
isis [ tag ]
undo isis [ tag ]
View
System view
Parameter
tag: Name given to the IS-IS process. The name length should be no longer
than 128 characters. It can be 0, which means null.
Description
Using the isis command, you can enable the corresponding IS-IS routing process
and enter the IS-IS view. Using the undo isis command, you can cancel the
specified IS-IS routing process.
By default, IS-IS routing process is not started
For the normal operation of the IS-IS protocol, the isis command must be used to
enable the IS-IS process. Then the network-entity command is used to set a
Network Entity Title (NET) for the router. And, at last, the isis enable command is
used to enable each interface on which the IS-IS process runs. The IS-IS protocol is
actually enabled upon the completion of these configurations.
Only one IS-IS routing process can be started on one router.
For the related commands, see isis enable and network-entity.
Example
Start an IS-IS routing process, in which the system ID is 0000.0000.0002 and the
area ID is 01.0001.
[3Com] isis
[3Com-isis] network-entity 01.0001.0000.0000.0002.00
Syntax
isis authentication-mode { simple | md5 } password [ { level-1 | level-2 } [ ip | osi ] ]
undo isis authentication-mode { simple | md5 } password [ { level-1 | level-2 } [ ip |
osi ] ]
View
Interface view
Parameter
simple: Transmit the authentication password in simple text.
md5: Transmit the authentication password in MD5 encryption.
password: Specifies the authentication password.
level-1: Configures authentication password for Level-1.
Integrated IS-IS Configuration Commands 611