3Com 3031 Command Reference Manual page 297

Frame Relay Configuration Commands 297
Example
Display Frame Relay address mapping table.
<3Com> display fr map-info
Map Statistics for interface Serial1/0/2 (DTE)
DLCI = 100, IP INARP 100.100.1.1, Serial1/0/2
create time = 2002/10/21 14:48:44, status = ACTIVE
encapsulation = ietf, vlink = 14, broadcast
DLCI = 200, IP INARP 100.100.1.1, Serial1/0/2
create time = 2002/10/21 14:34:42, status = ACTIVE
encapsulation = ietf, vlink = 0, broadcast
DLCI = 300, IP 1.1.1.1, Serial1/0/2
create time = 2002/10/21 15:03:35, status = ACTIVE
encapsulation = ietf, vlink = 15
The above indicates the information of each MAP configured with Frame Relay
protocol.
For example, as for the first address mapping, the mapping indicates that PVC
(DLCI=100) on Serial1/0/2 establishes the address mapping with the peer end (IP
address is 100.100.1.1) through Inverse ARP. The time of creating the mapping is
2002/10/21 14:48:44, and its status is active. Encapsulation format is IETF, and
broadcast packet is available.
display fr pvc-info Syntax
display fr pvc-info [ interface interface-type interface-num ]
View
Any view
Parameter
interface-type interface-num: Used to specify the interface to be viewed. The
specified interface can be a main interface or a sub-interface. The whole
information will be displayed for the command without specifying an interface.
Description
Using the display fr pvc-info command, you can view the FR PVC table.
This command displays the statistics of the FR PVC status and receiving/sending
data on this VC.
For the related command, see fr dlci.
Example
Display the FR PVC table.
<3Com> display fr pvc-info
PVC statistics for interface Serial1/0/0 (DTE, physical UP)
DLCI = 100, USAGE = UNUSED (0000), INTERFACE = Serial1/0/0
create time = 2000/04/01 23:55:39, status = active