3Com 3031 Command Reference Manual page 622

622 C 6: R P
HAPTER OUTING
set-overload
silent-interface
ROTOCOL
Example
Clear the IS-IS data of neighbor whose system ID is 0000.0c11.1111.
<3Com> reset isis peer 0000.0c11.1111
Syntax
set-overload
undo set-overload
View
IS-IS view
Parameter
None
Description
Using the set-overload command, you can configure overload flag bit for the
current router. Using the undo set-overload command, you can reset the overload
flag bit.
By default, no overload bit is set.
If a router is configured with the overload bit, it will be ignored by other routers in
SPF calculation. (However the directly connected routes will not be ignored.)
When the overload threshold is set, other routers should not send this router the
packets which should be forwarded by it.
Example
Set overload flag bit on the current router.
[3Com-isis] set-overload
Syntax
silent-interface interface-type interface-number
undo silent-interface interface-type interface-number
View
IS-IS view
Parameter
interface-type: Specifies the interface type.
interface-number: Specifies the interface number.
Description
Using the silent-interface command, you can disable a specified interface to
transmit IS-IS packet. Using the undo silent-interface command, you can enable
the interface to transmit IS-IS packet.
By default, all the interface are allowed to transmit/receive IS-IS packets.