3Com 3031 Command Reference Manual page 132

132 C 2: S M & M C
HAPTER YSTEM AINTENANCE ANAGEMENT OMMANDS
View
System view
Parameter
interface-type: Interface type.
interface-number: Interface number.
subinterface-name: Subinterface type.
Description
Using the snmp-agent trap source command, you can specify the source address
from which Trap will be sent. Using the undo snmp-agent trap source command,
you can remove the Trap source address.
There is always a Trap address when the SNMP Trap message is being sent from a
server, no matter from which interface it is sent. This command can be used to
trace a special event.
For the related command, see snmp-agent trap enable, snmp-agent target-host.
Example
Specify the IP address of the Ethernet interface 1/0/0 as the source address of Trap
packet.
[3Com] snmp-agent trap source ethernet 1/0/0
snmp-agent usm-user Syntax
snmp-agent usm-user { v1 | v2c } user-name group-name [ acl acl-number ]
undo snmp-agent usm-user { v1 | v2c } user-name group-name
snmp-agent usm-user v3 user-name group-name [ [ authentication-mode { md5 |
sha } auth-password ] [ privacy des56 priv-password ] ] [ acl acl-number ]
undo snmp-agent usm-user v3 user-name group-name { local | engineid
engineid-string }
View
System view
Parameter
v1: V1 security mode the user uses.
v2c: V2C security mode the user uses.
v3: V3 security mode the user uses.
user-name: User name, in the range of 1 to 32 bytes.