3Com 3031 Command Reference Manual page 370

370 C 4: L L
HAPTER INK AYER
x25 default-protocol
x25 hunt-group
P
ROTOCOL
Example
Define the suppress processing of incoming access on the interface Serial0/0/0.
[3Com-Serial0/0/0] x25 cug-service incoming-access
Syntax
x25 default-protocol protocol-type
undo x25 default-protocol
View
Interface view
Parameter
protocol-type: Protocol type, may be IP.
Description
Using the x25 default-protocol command, you can set the default upper-layer
protocol carried over X.25 for the X.25 interface. Using the undo x25
default-protocol command, you can restore the default upper-layer protocol.
By default, IP is carried over X.25.
During X.25 SVC setup, the called device will check the call user data field of X.25
call request packet. If it is an unidentifiable one, the called device will deny the
setup of the call connection. However, a user can specify a default upper-layer
protocol carried over X.25. When X.25 receives a call with unknown CUD, the call
can be treated based on the default upper-layer protocol specified by a user.
For the related command, see x25 map.
Example
Set the default upper-layer protocol over the X.25 interface Serial0/0/0 as IP.
[3Com-Serial0/0/0] x25 default-protocol ip
Syntax
x25 hunt-group hunt-group-name { round-robin | vc-number }
undo x25 hunt-group hunt-group-name
View
System view
Parameter
hunt-group-name: Name of hunt group.