3Com 3031 Command Reference Manual page 476

476 C 5: N P
HAPTER ETWORK ROTOCOL
Description
Using the debugging ip multicast-policy command, you can enable the debugging
of IP multicast policy routing. Using the undo debugging ip multicast-policy
command, you can disable the debugging of multicast policy routing.
The contents of the debugging information contain the route-node that the
packets match and the next hop/outgoing interface to which the packets are
forwarded. The debugging information output can be filtered with the
interface-based ACL.
It should be noted that enabling the debugging would affect the performance of
the system. You should disable the debugging when the system is running
normally.
For the related command, see route-policy.
display ip
Syntax
multicast-policy
display ip multicast-policy [ setup interface interface-name | statistic interface
interface-name ]
View
Any view
Parameter
interface-name: Interface name.
Description
Using the display ip multicast-policy command, you can view the multicast policy
routing information.
Example
Display the information about the multicast policy routing configured on interface
Ethernet2/0/0.
[3Com] display ip multicast-policy setup interface ethernet2/0/0
route-policy cc permit node 10
if-match acl 110
apply ip-address next-hop acl 50
route-policy cc permit node 20
if-match acl 120
apply output-interface acl 1005
Display the statistic information about the multicast policy routing configured on
interface Ethernet2/0/0.
[3Com] display ip multicast-policy statistic interface ethernet2/0/0
interface Ethernet2/0/0 multicast-policy routing summary
information:
Total packets matched: 5
Total packets forward : 20
if-match acl
Syntax
if-match { acl acl-number | ip-prefix ip-prefix-name }
undo if-match { acl acl-number | ip-prefix ip-prefix-name }