3Com 3031 Command Reference Manual page 763

Out Octets of Mpls interface is: 0
Out Packets of Mpls interface is: 0
Out Errors of Mpls interface is: 0
Out Discard Packets of Mpls interface is: 0
The statistics of interface : Serial6/0/1
The statistics of interface in :
In Octets of Mpls interface is: 0
In Packets of Mpls interface is: 0
In Errors of Mpls interface is: 0
In Discard Packets of Mpls interface is: 0
The statistics of interface out :
Out Octets of Mpls interface is: 0
Out Packets of Mpls interface is: 0
Out Errors of Mpls interface is: 0
Out Discard Packets of Mpls interface is: 0
Table 1 Description of the Output Information of the Display mpls statistics interface all
Command
Field
In Octets of Mpls interface is: 0
In Packets of Mpls interface is: 0
In Errors of Mpls interface is: 0
In Discard Packets of Mpls interface is: 0
Out Octets of Mpls interface is: 0
Out Packets of Mpls interface is: 0
Out Errors of Mpls interface is: 0
Out Discard Packets of Mpls interface is: 0
lsp-trigger Syntax
lsp-trigger { all | ip-prefix ip-prefix }
undo lsp-trigger { all | ip-prefix ip-prefix }
View
MPLS view
Parameter
all: Sets up LSPs at any routes.
ip-prefix: Sets up LSPs only at those routes with the specified IP prefix.
ip-prefix: IP address prefix list, in the range of 1~19.
Description
Using the lsp-trigger command, you can configure topology-triggered LSP creation
policy. Using the undo lsp-trigger command, you can remove the filtering
conditions specified by parameters and enable no route to trigger LSP creation.
By default, all kinds of routing protocols are filtered out.
If no topology-triggered policy is configured, LSPs can be established at all host
routes with 32-bit masks.
Basic Configuration Commands
Description
Bytes coming from the interface
Packets coming from the interface
Packet processing errors coming from the
interface
Discarded packets coming from the interface
Bytes sent from the interface
Packets sent from the interface
Packet processing errors sent from the
interface
Discarded packets sent from the interface
763