3Com 3031 Command Reference Manual page 648

648 C 6: R P
HAPTER OUTING
peer allow-as-loop
peer as-number
ROTOCOL
Description
Using the peer advertise-community command, you can enable the transmission
of the community attribute to a peer/peer group. Using the undo peer
advertise-community command, you can cancel the existing configuration.
By default, the community attribute is not transmitted to any peer/peer group.
For the related commands, see if-match community-list and apply community.
Example
Enable the transmission of the community attribute to a peer group "test".
[3Com-bgp] peer test advertise-community
Syntax
peer { group-name | peer-address } allow-as-loop [ number ]
undo peer { group-name | peer-address } allow-as-loop
View
BGP view, VPNv4 view, VPN instance view
Parameter
group-name: Specifies the name of peer group.
peer-address: Specifies the IP address of the peer.
number: Specifies the repeating times of local AS number. The range is 1 to 10.
Description
Using the peer allow-as-loop command, you can configure the repeating time of
local AS. Using the undo peer allow-as-loop command, you can remove the
repeating time of local AS.
For the related command, see display current-configuration, display bgp
routing-table peer, and display bgp routing-table group.
Example
Specify to configure the repeating times of local AS to 2.
[3Com-bgp] peer 1.1.1.1 allow-as-loop 2
Syntax
peer { group-name } as-number as-number
undo peer { group-name } as-number as-number
View
BGP view
Parameter
group-name: Specifies the name of peer group.
peer-address: Specifies the IP address of the peer.
as-number: Peer AS number of the peer/peer group. The range is 1 to 65535.