3Com 3031 Command Reference Manual page 330

330 C 4: L L
HAPTER INK AYER
display atm class
P
ROTOCOL
Since the use of this command can lead to a mass of output information during each packet
receiving and transmitting, this may cause that users cannot control network devices through
their terminals, and thus greatly affect the efficiency of packet transmitting and receiving.
Example
The example is a case to enable the debugging of ATM packet and display the
results.
Enable all the packet debugging of ATM.
<3Com> debugging atm packet
After some time, the following messages may appear:
......
*515396.229644-atm-8-debug8:
22
*515396.229710-atm-8-debug8:
01 04 05 DC
*515396.229812-atm-8-debug8:
*515396.232644-atm-8-debug8:
22
*515396.232710-atm-8-debug8:
01 04 05 DC
*515396.232812-atm-8-debug8:
It indicates that PPP packets are being output from PVC 1/32 of Atm1/0/0.
Syntax
display atm class [ atm-class-name ]
View
Any view
Parameter
atm-class-name: ATM-Class name.
Description
Using the display atm class command, you can view the information about
ATM-Class. By default, if no ATM-Class name is specified, the information of all
ATM-Class is displayed.
For the related command, see atm class.
Example
Display the information about the ATM-Class named "main" in devices.
<3Com> display atm class main
The following information is displayed:
Atm1/0/0 pvc 1/32 out ppp pkt, snap,
FE FE 03 CF FF 03 C0 21 01 22 00 0E
05 06 00 00 1F 38
Atm1/0/0 pvc 1/32 out ppp pkt, snap,
FE FE 03 CF FF 03 C0 21 01 23 00 0E
05 06 00 00 1F 38