3Com 3031 Command Reference Manual page 513

<3Com> display llc2 circuit 46465025
llc2 circuit index 46465025
dlsw bridge-set Syntax
dlsw bridge-set bridge-set-number
undo dlsw bridge-set bridge-set-number
View
System view
Parameter
Description
Using the dlsw bridge-set command, you can configure the bridge group to
connect DLSw . Using the undo dlsw bridge-set command, you can delete the
bridge.
In order to forward packets of specified bridge group to the remote end through
the TCP connection, a local bridge group needs to be connected with the DLSw by
using this command, that is, packets of the local bridge group can be sent to the
remote end through the TCP tunnel. This command can be used many times to
connect many bridge groups with the DLSw, and make them all capable of joining
the forwarding through the TCP tunnel.
Example
Configure the bridge group connected with the DLSw, with the ID of the bridge
group being 20.
[3Com] dlsw bridge-group 20
dlsw enable
Syntax
dlsw enable
undo dlsw enable
View
System view
Parameter
None
Description
Using the dlsw enable command, you can enable the DLSw performance. Using
the undo dlsw enable command, you can suspend the DLSw performance.
By default, the DLSw performance is enabled.
Local MAC 0.20.35.7b.e0.65
Remote MAC 0. 0.84.25.1e.e9
Local Sap 4
Remote Sap 4
Role secondary
State : NORMAL
bridge-set-number: ID of bridge group, ranging from 1 to 63, local valid.
DLSw Configuration Commands 513