3Com 3031 Command Reference Manual page 764

764 C 8: MPLS B C C
HAPTER ASIC ONFIGURATION OMMANDS
If you import an IP-prefix rule without contents, LSPs can be established at all host
routes according to the IP-prefix usage convention in VRP.
For the related command, see ip ip-prefix.
Example
Allow to set up LSPs at all routes.
[3Com-mpls] lsp-trigger all
mpls Syntax
mpls
View
System view, routing protocol view, interface view, virtual interface view
Parameter
None
Description
Using the mpls command in system view, you can enter MPLS view.
Using the mpls command in interface view, you can enable MPLS on the interface.
By default, MPLS view is not to be entered.
After executing the command, the user can enter MPLS view. Only after entering
MPLS view, can the user configure other MPLS commands.
To enter MPLS view, the user should configure the mpls lsr-id command first.
For the related command, see mpls enable | disable.
Example
Enter MPLS view in system view.
[3Com] mpls
[3Com-mpls]
Execute MPLS in interface view.
[3Com-Ethernet6/0/0] mpls
Mpls starting, please wait... OK!
mpls lsr-id Syntax
mpls lsr-id ip-address
undo mpls lsr-id
View
System view