3Com 3031 Command Reference Manual page 483

Example
Enable IPX RIP packet debugging switch
<3Com> debugging ipx rip packet
Switch on interface change debugging for IPXRM module.
<3Com>debugging ipx rtpro-interface
<3Com>
Trigger interface change by using shut/undo shut command.
[3Com-Serial1] shut
[3Com-Serial1]
%Oct 24 14:11:27 2003 3Com PHY/2/PHY:
%Oct 24 14:11:27 2003 3Com IFNET/5/UPDOWN:Line protocol on the interface
Serial1 turns into DOWN state
%Oct 24 14:11:27 2003 3Com IFNET/5/UPDOWN:Protocol IPX on the interface
Serial1 turns into DOWN state
*0.19023320 3Com RMX/8/DBG:IPXRM recieve interface change msg, msg type
IPX_IF_DOWN .if_index is 0x286 .Interface name is Serial1 .
[3Com-Serial1]
[3Com-Serial1]undo shut
[3Com-Serial1]
%Oct 24 14:11:34 2003 3Com PHY/2/PHY:
%Oct 24 14:11:34 2003 3Com IFNET/5/UPDOWN:Line protocol on the interface
Serial1 turns into UP state
%Oct 24 14:11:34 2003 3Com IFNET/5/UPDOWN:Protocol IPX on the interface
Serial1 turns into UP state
*0.19032220 3Com RMX/8/DBG:IPXRM recieve interface change msg, msg type
IPX_IF_UP .if_index is 0x286 .Interface name is Serial1 .
[3Com-Serial1]
debugging ipx Syntax
rtpro-routing
debugging ipx rtpro-routing
undo debugging ipx rtpro-routing
View
User view
Parameter
None
IPX Configuration Commands
Serial1: change status to down
Serial1: change status to up
483