3Com 3031 Command Reference Manual page 207

ATM E3/T3 Interface Configuration Commands 207
Parameter
interface-number: Interface number of ATM E3/T3.
Description
Using the display interface atm command, you can view the configuration and
status of ATM E3/T3 interface. If no interface-number is specified, the system will
display the configuration and status of all ATM interfaces.
Example
View the configuration and status of ATM E3/T3 interface 1/1/0.
<3com> display interface atm 1/1/0
frame-format Syntax
frame-format { g832-adm | g751-adm | g751-plcp }
frame-format { cbit-adm | cbit-plcp | m23-adm | m23-plcp }
undo frame-format
View
ATM E3/T3 interface view
Parameter
g832-adm: Configures frame format of ATM E3 as G.823 ATM direct mapping.
g751-adm: Configures frame format of ATM E3 as G.751 ATM direct mapping.
g751-plcp: Configures frame format of ATM E3 as G.751 Physical Layer
Convergence Protocol (PLCP).
cbit-adm: Configures frame format of ATM T3 as C-bit ATM direct mapping.
cbit-plcp: Configures frame format of ATM T3 as C-bit PLCP.
m23-adm: Configures frame format of ATM T3 as M23 ATM direct mapping.
m23-plcp: Configures frame format of ATM T3 as M23 PLCP.
Description
Using the frame-format command, you can configure frame format of ATM E3/T3
interface. Using the undo frame-format command, you can restore the default
configuration.
By default, frame format g751-plcp is used for ATM E3 and cbit-plcp used for ATM
T3.