3Com 3031 Command Reference Manual page 450

450 C 5: N
HAPTER ETWORK
display ip socket
P
ROTOCOL
interface-number: Interface number.
interface-name: Interface name.
Description
Using the display ip interface command, you can view the information of IP
interfaces.
By default, if no interface is specified, the information about all IP interfaces will
be displayed.
This command is used to display all the information related to IP on the interface.
The information is helpful for fault diagnosis. For the related command, see
display interface.
Example
Display IP-related information at the interface Serial 0/0/0.
<3Com> display ip interface Serial 0/0/0
Serial 0/0/0 current state : UP
Line protocol current state : UP
Internet Address : 10.10.10.10/16
Broadcast address : 10.10.255.255
The Maximum Transmit Unit : 1500 bytes
input packets : 1231, bytes : 57557, multicasts : 1177
output packets : 0, bytes : 0, multicasts : 0
The above information shows that the physical link state of the interface serial
0/0/0 is UP, link-layer protocol state is UP, the maximum transmit unit is 1500
bytes, the IP address is 10.10.10.10, the broadcast subnet is 10.10.255.255 and
the packet receiving/sending conditions at this interface.
Syntax
display ip socket [ socktype sock_type ] [ task_id socket_id ]
View
Any view
Parameter
sock_type: The type of a socket: (tcp:1, udp 2, raw ip 3)
task_id: The ID of a task.
socket_id: The ID of a socket.
Description
Using the display ip socket command, you can display the information about all
sockets in the current system.
Example
Display the information about the socket of TCP type.
<3Com> display ip socket socktype 1
SOCK_STREAM:
Task = VTYD(9), socketid = 1, Proto = 6,
LA = 0.0.0.0:23, FA = 0.0.0.0:0,