3Com 3031 Command Reference Manual page 333

ATM Configuration Commands 333
Example
Display the information about the upper layer protocol mapping table of all ATM
interfaces.
<3Com> display atm map-info
The following information is displayed:
Atm1/0/0, PVC 1/32, PPP, Virtual-Template10, UP
Atm1/0/0, PVC 1/33, IP & Mask, State UP
100.11.1.1, mask 255.255.0.0, vlink 1
Atm1/0/0, PVC 2/101, ETH, Virtual-Ethernet1/1/1, MAC 00E0.FC01.0203,
UP
The explanation on the above messages is:
PVC 1/32 of Atm 1/0/0 interface uses PPPoA mapping, the VT interface numbered
10 is used and the status is activated (UP);
PVC 1/33 of Atm 1/0/0 interface uses IPoA mapping, the configured mapping
static IP address is 100.11.1.1, the address mask is 255.255.0.0, it occupies No.1
vlink and its status is activated (UP);
PVC 2/101 of Atm 1/0/0 interface uses PPPoEoA mapping or IPoEoA mapping, VE
interface numbered 1/1/1 is adopted, the configured MAC address is
00E0.FC01.0203 and its status is activated (UP).
display atm pvc-group
Syntax
display atm pvc-group [ interface { interface-name | interface-type interface-num }
[ pvc { pvc-name [ vpi/vci ] | vpi/vci } ] ]
View
Any view
Parameter
interface-name: ATM interface name. The detailed naming rules can be
determined according to the actual-configured network device type. If it is not
specified, all the information about PVC-Group of ATM interface will be displayed
by default.
interface-type: Interface type, which can determine an ATM interface together
with interface-num.
interface-num: Interface number, which can determine an ATM interface together
with interface-type.
pvc-name: PVC name, optional. If no PVC name and no VPI/VCI pair are specified,
the information about all PVC-Groups within the specified ATM interface will be
displayed by default.