3Com 3031 Command Reference Manual page 546

546 C 6: R P
HAPTER OUTING
default cost
ROTOCOL
Example
Configure not to perform zero check for RIP-1 packet.
[3Com-rip] undo checkzero
debugging rip
Syntax
debugging rip { packet | receive | send }
View
User view
Parameter
packet: Enables the RIP packets debugging.
receive: Enables the RIP receiving packets debugging.
send: Enables the RIP sending packets debugging.
Description
Using the debugging rip command, you can enable the RIP packet debugging.
Using the undo debugging rip command, you can disable the RIP packet
debugging.
Users can learn the current information of receiving and sending RIP packets on
each interface by using this command.
Example
Enable the RIP packets debugging.
<3Com> debugging rip packet
Syntax
default cost value
undo default cost
View
RIP view
Parameter
value: Default routing cost to be set, ranging from 1 to 16.The default value is
1.
Description
Using the default cost command, you can configure the default routing cost of an
imported route. Using the undo default cost command, you can restore the
default value.
If no specific routing cost is specified when importing other protocol routes with
the import-route command, the importing will be performed with the default
routing cost specified by the default cost command.
For the related command, see import-route.