3Com 3031 Command Reference Manual page 627

aggregate Syntax
aggregate address mask [ as-set ] [ detail-suppressed ] [ suppress-policy
route-policy-name ] [ origin-policy route-policy-name ] [ attribute-policy
route-policy-name ]
undo aggregate address mask [ as-set ] [ detail-suppressed ] [ suppress-policy
route-policy-name ] [ origin-policy route-policy-name ] [ attribute-policy
route-policy-name ]
View
BGP view
Parameter
address: Address of the aggregated route, in dotted decimal notation.
mask: Network mask of the aggregated route, in dotted decimal notation.
as-set: Creates a route with AS segment.
detail-suppressed: Only advertise the aggregated route.
suppress-policy route-policy-name: Suppresses the specific route selected,
some of which are not advertised.
origin-policy route-policy-name: Selects the originating routes used for
aggregation.
attribute-policy route-policy-name: Sets the attributes of the aggregated route.
Description
Using the aggregate command, you can establish an aggregated record in the BGP
routing table. Using the undo aggregate command, you can cancel the function.
By default, there is no route aggregation.
The keywords are explained as follows:
Table 4 Functions of the keywords
Keywords
as-set
detail-suppressed
suppress-policy
origin-policy
attribute-policy
Example
Establish an aggregated record in the BGP routing table.
[3Com-bgp] aggregate 192.213.0.0 255.255.0.0
Function
Used to create an aggregated route, whose AS path information
includes detailed routes. Use this keyword carefully when many AS
paths need to be aggregated, for the frequent change of routes may
lead to route vibration.
This keyword does not establish any aggregated route, but it restrains
the advertisement of all the specific routes. If only some specific routes
are to be restrained, use the peer filter-policy command carefully.
Create an aggregated route with this keyword, at the same time, the
advertisement of the specified route is restrained. If you want to restrain
some specific routes selectively and leaves other routes still being
advertised, use the if-match clause of the route-policy command.
Select only the specific routes that are in accordance with route-policy
to create an aggregated route.
Set aggregated route attributes. The same work can be done by using
peer route-policy, etc.
BGP Configuration Commands 627