3Com 3031 Command Reference Manual page 732

732 C 7: M C C C
HAPTER ULTICAST OMMON ONFIGURATION OMMANDS
View
MSDP view
Parameter
interface-type: Interface type.
interface-number: Interface number.
Description
Using the originating-rp command, you can allow a MSDP to use the IP address of
specified interface as the RP address in the SA message originated. Using the undo
originating-rp command, you can remove the configuration.
By default, the RP address in the SA message is the RP address configured by PIM.
Configure logical RP by using this command.
Example
Configure IP address of the interface Ethernet1/0/0 as the RP address in the SA
message originated.
<3Com> system-view
<3Com] msdp
<3Com-msdp] originating-rp ethernet 1/0/0
peer Syntax
peer peer-address connect-interface interface-type interface-number
undo peer peer-address
View
MSDP view
Parameter
peer-address: Address of MSDP peer.
connect-interface interface-type interface-number: Interface type and number
whose primary address is used by the local router as the source IP address to
establish TCP connection with remote MSDP peers.
Description
Using the peer command, you can configure an MSDP peer. Using the undo peer
command, you can remove the MSDP peer configured.
If the local router is also in BGP peer relation with a MSDP peer, the MSDP peer
and the BGP peer should use the same IP address.
For the related command, see static-rpf-peer.
Example
Configure the router using IP address 125.10.7.6 as an MSDP peer of the local
router.