3Com 3031 Command Reference Manual page 473

ip local policy
route-policy
ip policy route-policy
undo if-match packet-length
View
Route-policy view
Parameter
min-len: Minimum packet length of network layer.
max-len: Maximum packet length of network layer.
Description
Using the if-match packet-length command, you can set length match conditions
of IP packets. Using the undo if-match packet-length command, you can delete
the configuration about IP packet length match conditions.
For the related command, see if-match acl.
Example
Set the packet in the range 100 to 200 to be matched.
[3Com] route-policy map1 permit node 10
[3Com-route-policy] if-match packet-length 100 200
Syntax
ip local policy route-policy policy-tag
undo ip local policy route-policy policy-tag
View
System view
Parameter
policy-tag: Policy name.
Description
Using the ip local policy route-policy command, you can enable local policy
routing. Using the undo ip local policy route-policy command, you can delete the
existing setting of the policy routing.
By default, interface local policy routing is disabled.
This command is used to enable or disable the local policy routing for the packets
sent by the local device. If there is no special demand, it is recommended that
users do not configure local policy routing.
For the related command, see ip policy route-policy.
Example
Enable a local policy routing at system view. The policy routing is specified by
route-policy AAA.
[3Com] ip local policy route-policy AAA
Syntax
ip policy route-policy policy-name
IP Unicast Policy Routing Configuration Commands 473