3Com 3031 Command Reference Manual page 391

normal proceeding of the local procedure. This parameter specifies the delay time
of this timer before the timeout.
For the related commands, see x25 timer tx0, x25 timer tx1, and x25 timer tx2.
Example
Set the delay time of clearing timer on the X.25 interface Serial0/0/0 to 100
seconds.
[3Com-Serial0/0/0] x25 timer tx3 100
x25 vc-per-map
Syntax
x25 vc-per-map count
undo x25 vc-per-map
View
Interface view
Parameter
count: Maximum number of VCs, and its value ranges from 1 to 8.By default, its
value is 1.
Description
Using the x25 vc-per-map command, you can set the maximum number of VCs for
connections with the same destination device. Using the undo x25 vc-per-map
command, you can restore their default values.
If the parameter is greater than 1, and the sending window and the sending
queue of VC are filled full, the system will create a new VC to the same
destination. If the new VC cannot be created, the datagram will be discarded.
For the related commands, see display interface and x25 map.
Example
Set the maximum value of VCs on the X.25 interface Serial 0/0/0 to 3.
[3Com-Serial0/0/0] x25 vc-per-map 3
x25 vc-range Syntax
x25 vc-range [ in-channel lic hic ] [ bi-channel ltc htc ] [ out-channel loc hoc ]
undo x25 vc-range
View
Interface view
LAPB and X.25 Configuration Commands 391