3Com 3031 Command Reference Manual page 587

View
Interface view
Parameter
Description
Using the ospf cost command, you can configure different packet sending costs so
as to send packets from different interfaces. Using the undo ospf cost command,
you can restore the default costs.
By default, the interface automatically calculates the costs required for running
OSPF protocol according to the current Baud rate.
Example
Specify the cost spent when an interface runs OSPF as 33.
[3Com] interface serial1/0/0
[3Com-Serial1/0/0] ospf cost 33
ospf dr-priority Syntax
ospf dr-priority value
undo ospf dr-priority
View
Interface view
Parameter
Description
Using the ospf dr-priority command, you can configure the priority for electing the
"designated router" on an interface. Using the undo ospf dr-priority command,
you can restore the default value.
Interface priority determines the interface qualification when electing the
"designated router". The interface with high priority is considered first when there
is collision in election.
Example
Set the priority of the interface Ethernet1/0/0 to 8, when electing the DR.
[3Com] interface Ethernet1/0/0
[3Com-Ethernet1/0/0] ospf dr-priority 8
ospf mib-binding Syntax
ospf mib-binding process-id
undo ospf mib-binding
View
System view
value: Cost for running OSPF protocol, ranging from 1 to 65535.
value: Interface priority for electing the "designated router", ranging from 0 to
255. By default, the value is 1.
OSPF Configuration Commands 587