3Com 3031 Command Reference Manual page 555

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

Using the rip authentication-mode md5 type command, you can configure md5

type of RIP-2 authentication

By default, use nonstandard type.

RIP-2 packets can be in the following two formats when MD5 authentication is

adopted: The earlier raised format is described in RFC1723, which is adopted by

Gated. Another format fits into RFC2082 standard, which is adopted by part of

the routers in the industry.

For the related commands, see rip authentication-mode and rip version.

Set MD5 authentication at Serial0, and the packet type is "nonstandard".

[3Com] interface serial1/0/0

[3Com-Serial1/0/0] rip version 2

[3Com-Serial1/0/0] rip authentication-mode md5 type nonstandard

undo rip input

Interface view

Using the rip input command, you can allow an interface to receive RIP packets.

Using the undo rip input command, you can cancel an interface to receive RIP

By default, RIP packets at all interfaces (except loopback interface) can be

This command is used in cooperation with the other two commands: rip output

and rip work. Functionally, rip work is equivalent to rip input & rip output. The

latter two control the receipt and the transmission of RIP packets respectively on

an interface. The former command equals the functional combination of the latter

two commands.

For the related command, see rip output and rip work.

Specify the interface serial1/0/0 not to receive RIP packets.

[3Com-serial1/0/0] undo rip input

rip metricin

rip metricin value

undo rip metricin

RIP Configuration Commands