3Com 3031 Command Reference Manual page 346

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

vpi: Virtual path identifier of ATM network, its value ranges from 0 to 255.

peak-rate: Normal flow to be held. Value range of this parameter depends on

interface type, as shown in the following table:

Table 17 Value ranges of peak-rate

Interface type

Using the pvp limit command, you can set the parameters for VP policing. Using

the undo pvp limit command, you can delete the VP policing.

By default, the VP policing is not performed.

When applying VP policing, the parameters of PVC are still valid. Only when the

parameters of PVC and VP policing are satisfied, will the packets be transmitted.

When calculating the traffic, the LLC/SNAP, MUX and NLPID headers are included,

but the ATM cell head is not included.

For the related commands, see pvc, service cbr, service vbr-nrt, and service vbr-rt,

service ubr.

Set the traffic of VP with vpi 1 to 2M.

[3Com-Atm1/0/0] pvp limit 1 2000

service cbr output-pcr [ cdvt cdvt_value ]

output-pcr: Output peak rate of ATM cell in Kbit/s. Value range of this parameter

depends on interface type, as shown in the following table

Table 18 Value ranges of output-pcr

Interface type

<2000-155000>