3Com 3031 Command Reference Manual page 493

IPX Configuration Commands 493
Restore the default IPX frame encapsulation format on the interface
Ethernet0/1/0.
[3Com-Ethernet 0/1/0] undo ipx encapsulation
ipx netbios-propagation Syntax
ipx netbios-propagation
undo ipx netbios-propagation
View
Interface view
Parameter
None
Description
Using the ipx netbios-propagation command, you can configure the router to
forward type 20 broadcast packets on the current interface. Using the undo ipx
netbios-propagation command, you can disable the forwarding of type 20
packets.
By default, type 20 broadcast packets will be discarded by the router rather than
forwarded.
IPX type 20 packet is a packet for NetBIOS (Network Basic Input/Output System)
defined by Novell NetWare.
Example
Enable the receipt and forwarding of type 20 broadcast packets.
[3Com-Ethernet 0/1/0] ipx netbios-propagation
Disable the receipt and forwarding of type 20 broadcast packets.
[3Com-Ethernet 0/1/0] undo ipx netbios-propagation
ipx network Syntax
ipx network network-number
undo ipx network
View
Interface view
Parameter
network: Network ID of IPX interface in hex. It ranges from 0x1 to FFFFFFFD.
Description
Using the ipx network command, you can configure a network ID for an interface.
Using the undo ipx network command, you can delete IPX network ID of an
interface.
By default, IPX is disabled on all interfaces after it is activated. There is no IPX
network ID on the interface.