3Com 3031 Command Reference Manual page 618

618 C 6: R P
HAPTER OUTING
isis timer retransmit
is-level
ROTOCOL
View
Interface view
Parameter
time: Specifies the LSP interval, ranging from 1 to 1000 and measured in
milliseconds. The default value is 33 milliseconds.
Description
Using the isis timer lsp command, you can configure minimum IS-IS LSP interval on
the interface. Using the undo isis timer lsp command, you can restore the default
setting.
For the related command, see isis timer retransmit.
Example
Set the LSP interval on Interface serial1/0/0 to 500 milliseconds.
[3Com] interface Interface serial1/0/0
[3Com-Serial1/0/0] isis timer lsp 500
Syntax
isis timer retransmit seconds
undo isis timer retransmit
View
Interface view
Parameter
seconds: Specifies the retransmission interval of LSP packets, with the range
from 0 to 300 and the default value is 5 seconds.
Description
Using the isis timer retransmit command, you can configure the LSP retransmission
interval over the point-to-point link. Using the undo isis timer retransmit
command, you can restore the default setting.
Use this parameter cautiously when setting this parameter to avoid unnecessary
retransmission.
The response is required when sending LSP packets on the p2p link, not the
broadcast link, and therefore this command is unnecessary for the broadcast link.
For the related command, see isis timer lsp.
Example
Set the LSP retransmission interval to 10 seconds on Interface serial1/0/0.
[3Com] interface serial1/0/0
[3Com-Serial1/0/0] isis timer retransmit 10
Syntax
is-level { level-1 | level-1-2 | level-2 }
undo is-level