3Com 3031 Command Reference Manual page 755

Multicast Static Route Configuration Commands 755
mask: IP address mask of multicast source.
Description
Using the display multicast routing-table static config command, you can view
multicast static routes configured.
If no multicast source address is specified, all configured multicast static routes will
be displayed.
For the related command, see display multicast routing-table static.
Example
Display all the configured multicast static routes.
<3Com> display multicast routing-table static config
Display the multicast static routes that exactly match the address 1.0.0.0/8.
<3Com> display multicast routing-table static config 1.0.0.0
255.0.0.0
ip rpf-longest-match Syntax
ip rpf-longest-match
undo ip rpf-longest-match
View
System view
Parameter
None
Description
Using the ip rpf-longest-match command, you can configure the longest-match
rule to be the multicast RPF route selecting policy. Using the undo ip
rpf-longest-match command, you can restore the default configuration.
By default, routes are selected according to the preference-preferred rule.
Example
Set the longest-match rule to be the multicast RPF route selecting policy.
<3Com] ip rpf-longest-match
ip rpf-route-static Syntax
ip rpf-route-static source { mask | mask-length } [ protocol ] [ route-policy
policyname ] { rpf-nbr | interface-name } [ order order-num | preference preference
]
undo ip rpf-route-static source { mask | mask-length } [ protocol ] [ route-policy
policyname ]