3Com 3031 Command Reference Manual page 484

484 C 5: N
HAPTER ETWORK
debugging ipx sap
packet
P
ROTOCOL
Description
Using the debugging ipx rtpro-routing command, you can turn on the debugging
switch of route change in the IPXRM module. Using the command, you can turn
off the debugging switch of route change in the IPXRM module.
This kind of debugging information is generated when route changes as addition,
deletion or attribute adjustment occur.
Example
Switch on route change debugging for IPXRM module.
<3Com>debugging ipx rtpro-routing
<3Com>
Add a static route
3Com]ipx route-static d10 Serial 1
*0.19579120 3Com RMX/8/DBG:IPXRM ADD route !
Dest: d10
Interface: a.00e0-fcfb-3a00(Serial1)
Protocol: Static
Ticks: 6
*0.19579230 3Com RMX/8/DBG:IPXRM route change to ACTIVE !
Dest: d10
Interface: a.00e0-fcfb-3a00(Serial1)
Protocol: Static
Ticks: 6
Syntax
debugging ipx sap [ packet [ verbose ] | event ]
undo debugging ipx sap [ packet [ verbose ] | event ]
View
User view
Parameter
packet: Debugging information of packet received and transmitted.
verbose: Displays detailed information about packet received and transmitted.
event: Event debugging information, such as Up/Down of an interface and
related timer events.
Description
Using the debugging ipx sap command, you can enable IPX SAP debugging switch
to view information on SAP packet received and transmitted, routing changes and
Nexthop: 0.0000-0000-0000
Preference: 60
Hops: 1
Nexthop: 0.0000-0000-0000
Preference: 60
Hops: 1