3Com 3031 Command Reference Manual page 287

ISDN Configuration Commands 287
undo isdn spid2
View
ISDN BRI interface view
Parameter
spid: String comprising 1 to 20 digits.
Description
Using the isdn spid2 command, you can configure SPID information for the B1
channel on an NI-compliant BRI interface. Using the undo isdn spid2 command,
you can remove the SPID information of the B1 channel on the interface.
On a BRI interface compliant with the ISDN protocol in North America, calls can be
placed only after the SPID negotiation or initialization is finished. SPID information
can be obtained via static configuration or dynamic negotiation. Only after SPID
information is configured for the B2 channel on the BRI interface can the system
makes the L3 initialization to place calls normally.
By default, SPID for the B2 channel on a BRI interface is null.
This command applies only on NI-compliant BRI interfaces.
Example
Set SPID to "012345" for the B2 channel on the interface bri0/0/0.
[3Com-bri0/0/0] isdn spid2 012345
isdn statistics Syntax
isdn statistics { clear | continue | display [ flow ] | start | stop }
View
ISDN interface view
Parameter
clear: Clears the statistics.
continue: Continues counting.
display: Displays the statistics.
display flow: Displays the statistic information about message flows.
start: Starts counting.
stop: Stops counting.