3Com 3031 Command Reference Manual page 226

226 C 3: I
HAPTER NTERFACE
display dsl version
M C
ANAGEMENT OMMANDS
LOS(LOS):
ATM Defects
NCDI(ncd-I):
NCDF(ncd-F):
LCDI(lcd-I):
LCDF(lcd-F):
Table 8 Displaying information with display dsl status
Field
State of driver/chipsetsInterface state and transceiver state
Phy
Xcvr
The following information appears after the link is activated.
Active Params
Adsl Count
Adsl Defects
Syntax
display dsl version interface atm interface-number
View
Any view
Parameter
interface-number: Interface number.
Description
Using the display dsl version command, you can display the DSL version
information and the supported capabilities.
Example
Display the ADSL version information.
[3com-Atm1/0/0]display dsl version interface atm 1/0/0
Adsl board chipset and version info
Dsl Line Type:
0
0
0
0
0
Description
Interface state and options include activating, active, startup,
deactivated and test mode
Transceiver state and options include idle, data mode, handshaking and
training.
Link parameters, which include SNR margin, attenuation, Tx Bin
Number etc. The Present rate(kbps) is consistent with the result of the
display dsl configuration command.
Error and correction statistics form the chipset. For their types, refer to
ITU-T G. 992 and ANSI T1.413-1998.
It shows the current link situation. When the link has deteriorated,
non-zero value may appear. While it turns to normal or is activated
again, those existing statistics are cleared. The Overall failures value is a
aggregate value, but others are not.
Adsl Over Pots
0
0
0
0
0